Friday , January 24th 2020
    All about internat computer replacement in one place

pzsmocn Electronic Ink Screen,2.13inch e-Paper HAT,Flexible Ink Bare Screen,Flexible Screen,212 104 Resolution,Suitable for Curved Surfaces Industrial Instruments and Smart Wearable Device,etc.

Product Features:

    Product Introduction This can be a versatile E-Ink show HAT for Raspberry Pi, 2.13inch, 212*104 decision, with embedded controller, speaking by way of SPI interface, helps partial refresh. In contrast with regular e-Paper panels, this versatile panel permits bending with out being broken, and it is thinner and lighter.…
Price as on: 2019-12-13 05:48:28
27.97  

Product Description

Product Introduction

This can be a versatile E-Ink show HAT for Raspberry Pi, 2.13inch, 212*104 decision, with embedded controller, speaking by way of SPI interface, helps partial refresh.

In contrast with regular e-Paper panels, this versatile panel permits bending with out being broken, and it is thinner and lighter.

Mixed with the benefits like extremely low energy consumption, large viewing angle, clear show with out electrical energy, it is a perfect alternative for functions the place curved floor show is required, corresponding to industrial devices, sensible wearable-devices,and so forth.

Product Function

Versatile e-Paper, the show part is bendable (DON’T bend the FPC part)

No backlight, retains displaying final content material for a very long time even when energy down

Extremely low energy consumption, mainly energy is simply required for refreshing

Appropriate with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+

Preserved solder pads for SPI interface, for connecting with different controller boards like Arduino/Nucleo, and many others.

Product Parameter

Working voltage: 3.3V

Interface: 3-wire SPI, 4-wire SPI

Define dimension: 59.2mm * 29.2mm * 0.3mm

Show dimension: 23.71mm * 48.55mm

Dot pitch: 0.229 * 0.228

Decision: 212 * 104

Show shade: black, white

Gray degree: 2

Full refresh time: 2s

Refresh energy: 26.4mW(typ.)

Standby energy:Lower than 0.017mW

Viewing angle: Greater than 170°

Interface

VCC :3.3V / 5V

GND :Floor

NC :NC

DIN :SPI MOSI pin

CLK :SPI SCK pin

CS :SPI chip choice, low energetic

DC :Knowledge/Command choice (excessive for information, low for command)

RST :Exterior reset, low energetic

BUSY :Busy standing output, low energetic

Transport Record

1.2.13inch e-Paper * 1

2.e-Paper Driver HAT * 1

3.RPi screws pack (2pcs) * 1

4.PH2.0 20cm 8Pin * 1

Product Options

  • Versatile e-Paper, the show part is bendable (DON’T bend the FPC part).
  • No backlight, retains displaying final content material for a very long time even when energy down.
  • Extremely low energy consumption, mainly energy is simply required for refreshing.
  • Appropriate with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+.
  • Preserved solder pads for SPI interface, for connecting with different controller boards like Arduino/Nucleo, and many others.